Categories: Construction Progress, Uncategorized
Written By: roo
I finally got to the tail light, I had been running a regular 4″ truck tail light double taped to the ‘POD and it was time to put the final light in. LED SUPPLY ( WWW.LEDSUPPLY.COM) sponsored this project with donations of their EndorStar high powered LED’s and Buckpuck and Powerpuck drivers (and lots of advice on how to use them) I used a stick-on reflector lens for the brake light (still reflects too!) and the appropriate optic for the back-up light. The housing is machined aluminum that doubles as a heat sink for the high powered LED’s. The little perfboard circuit provides the need electronics to isolate the tail from the brake light and switches in a resistor for the tail light control circuit that dims it (it uses a little 12v relay and a couple of diodes). Anyway, check out the pictures and please visit LED SUPPLY’S website…really great service and very cool LED’S!